My Silhouette Mat Is Not Sticky

Soak in dawn soap i did it for 24 hrs.

My silhouette mat is not sticky.

Drag the silhouette mat over to the sink for a rinse. I went to a convention and this is what the cricut guy told me. Cricut mats come in several different variants but the method of cleaning should be more or less the same. Once this is cleaned reasonably well wipe over your mat with a baby wipe.

All the small bits of paper vinyl and fluff that is reducing the mats ability to stay sticky. This will make it less likely for problems to occur when placing your mat in your silhouette cameo. The top mat with the cloudy type of adhesive is the real silhouette cameo cutting mat. You should be able to see all the nasties coming off your mat.

You ll find this guide useful when you need to re use an old cricut a silhouette mat or a cake mat that s used for baking. You want to make sure the mat is fully dry before applying the spray adhesive. It s obvious the adhesive is different which is most likely why the fake mats become unsticky within just two to three weeks of use. My mat is no longer sticky in the area i used the wipe on melissa l.

Grab your sponge and start a scrubbin. Take the dirty silhouette cutting mat and lay it on a flat surface such as a counter or table. Or you can pat the palm of your hands on it too and the natural oils from your hands will also release some of the adhesive making it less sticky. It will be hard for the rollers to run if your they are getting stuck on the sticky part of your mat.

If you see that you haven t gotten all the old sticky mess off just repeat steps 2 4 until it s nice and clean. Then use a scraper and scrape off the stuff left on the mat and dry then take reposition tape runner all over mat. You will need an area around the outside that is not sticky. Make sure your mat is completely dry before using it again.

First of all use your scraper to clean off all the debris that has built up on the mat. Start with 1 coat. You ll save a perfectly good cricut mat a few dollars and it can be a fun project to boot. Open the bottle of goo gone and dribble a little around the mat.

The bottom mat is the fake. This is to prevent any adhesive that is added from getting onto the edges which may interfere with your machine s rollers. Once the edges of the mat are taped use a spray adhesive or glue stick.