Missed Spot Polyurethane Floor

How can i fix this without compounding the problem.

Missed spot polyurethane floor.

I am using minwax super fast drying clear satin. Dull spots in polyurethane floors usually indicate that the finish was not applied carefully the applicator had a dry spot on it or the finish was thinned out with a solvent such as mineral spirits. I have had repairs done on oak floors that resulted in refinishing small areas. This is how to polyurethane a spot on the floor with that refinishing the floor.

Typically two to three coats are used with sanding in between coats to even them out. Missed a spot applying poly. There s a sheen difference on the missed spots but the color is consistent. I tried touching it up by rolling on some poly but the finish is matte and somewhat cloudy from.

While applying the last coat of poly to a traditional 3 4 red oak strip floor in poor light i didn t overlap the edge for about about 10 12 and the width of one of the boards. Missed spots in polyurethane on hardwood floor. It looks remarkably good. Can i just add some polyurethane coating to the missed spots or is that going to cause an issue.

Using a good quality polyurethane and a china bristle brush and three differ. Focus on that one small area and ignore the rest of the floor. With a little tender loving care they can keep their soft shine for years. When it comes to finishing furniture or hardwood floors polyurethane is the key to protecting and preserving the stain.

The process is straightforward. Once the finish is dry you can do minor repairs and that s easier than repairing a big area of overworked finish. Applying polyurethane in even coats is a crucial though not always simple task. The part i missed is pretty evident in the correct light.

The dull and shiny spots in your hardwood floor indicate that your installers did not apply the finish correctly. But even the most careful. I m wondering how long this coat will really last given it wasn t sanded first. Use solvent based polyurethane and get the same finish type gloss satin etc and apply a few thick coats.

I assume that you have a polyurethane floor so i will base my answer on that. I put a final coat of polyurethane on my wood floors and noticed that i missed a spot where my roller didn t overlap in application after the floor completely dried. Hardwood floors add a warm and natural glow to any room. Sand the area clean it with a solvent afterwards denatured alcohol apply polyurethane let dry.